Comfort Glow Direct Vent Gas Burning Fireplaces

Vanguard Direct Vent Gas Burning Fireplaces Piping
Please note:
If you are buying piping for a 34, 37, or 41" unit you must buy an adapter so that the new vent kits listed below will fit your unit.

Vent Kit Adapters (Required For 34, 37, & 41" Fireplaces Only)

Model	Description
SE47-45	Vertical Adapter With 45 Degree Elbow
SE47-60	Horizontal Adapter With 60 Degree Elbow

4 1/4" x 7 1/4" Vent Kits

Model	Description
VKG-47	Basic Ground Floor Rigid Vent Kit Includes: (1) 45 degree elbow (1) 7"-12" Adjustable Pipe (1) Wall Thimble / Firestop (1) Horizontal Square Termination and Screws
VKS-47	Snorkel Rigid Vent Kit Includes: (1) 7" x 4' Pipe (1) 7" x 45 Degree Elbow (1) 7" x 90 Degree Elbow (1) 7"-12" Adjustable Pipe (1) Wall Thimble / Firestop (1) 36" Snorkel Termination and Screws
VKR-47	Roof Vent Kit Includes: (1) 7" x 4' Pipe (1) 7" x 2' Galvanized Pipe (1) 7" x 45 Degree Elbow (1) 7"-12" Adjustable Pipe (1) Firestop Support (1) 0/12-6/12 Roof Flashing (1) Storm Collar (1) Flue Restrictor (1) Vertical High Wind Termination and Screws
VKC-47	Corner Vent Kit Includes: (1) 7" x 6" Galvanized Pipe (1) 7" x 45 Degree Elbow (1) 7" x 90 Degree Elbow (1) 7"-12" Adjustable Pipe (1) Wall Thimble / Firestop (1) Horizontal Square Termination and Screws
VKB-47	Basement Vent Kit Includes: (1) 7" x 4' Pipe (1) 7" x 45 Degree Elbow (1) 7" x 90 Degree Elbow (1) 7"-12" Adjustable Pipe (1) Wall Thimble / Firestop (1) Horizontal Square Termination and Screws
HHTK	Horizontal Round Termination Kit Includes: (1) 7" x 45 Degree Elbow (1) Wall Thimble / Firestop (1) Horizontal Round Termination Piping sold separately!

4 1/4" x 7 1/4" Vent Kit Accessories

Model	Description
Piping (4 1/4" x 7 1/4" Galvanized Piping)
P47-6	6" Section Double Wall Pipe
P47-12	12" Section Double Wall Pipe
P47-24	24" Section Double Wall Pipe
P47-36	36" Section Double Wall Pipe
P47-48	48" Section Double Wall Pipe
PA47-712	Adjustable 7"-12" Section Double Wall Pipe
Elbows (4 1/4" x 7 1/4" Galvanized Piping)
E47-90	90 Degree Elbow
E47-45	45 Degree Elbow
FSE47-45	45 Degree Starter Elbow
Collars, Restrictors, & Supports (4 1/4" x 7 1/4" Galvanized Piping)
WS-47	Wall Strap/Offset Support
SC-47	Storm Collar
FP-47	Ceiling Firestop/Support
CS-47	Cathedral Ceiling Support
VR-47	Vertical Restrictor
Model	Description
Thimbles (4 1/4" x 7 1/4" Galvanized Piping)
WF-47	Wall Thimble
Roof Flashing (4 1/4" x 7 1/4" Galvanized Piping)
RF-47-6	Roof Flashing 0-6/12 Pitch
RF-47-12	Roof Flashing 6/12-12/12 Pitch
Standoff (4 1/4" x 7 1/4" Galvanized Piping)
S-47	Vinyl Siding Standoff
Model	Description
Terminations (4 1/4" x 7 1/4" Galvanized Piping)
VT-47	Vertical Round Termination
HT-47	Horizontal Round Termination
HTS-47	Horizontal Square Termination
ST-47-36	36" Snorkel Termination
HT-47-14	14" Snorkel Termination

Important Heater Information

Installation must be done by qualified service persons.
Read Owner's Manual before using.
Not for use in recreational vehicles.
All products approved for manufactured (mobile) home installation.
We reserve the right to amend product specifications without notice.
Use with adequate air (ventilation) only. Humidifies while it heats.
Provides water vapor in the area heated. Refer to owner's manual for specifics.
Heating areas based on rooms with 8" ceilings.
Operating heater at elevations above 4,500 ft. could cause nuisance outages.

Is Vent-Free Gas Heating Right For Me?
Product cannot be converted between fuel types.
ANSI Z21 11.2 Standard and National Fuel Gas Code revised in 1994 to permit wall mounted installations of vent-free gas heaters of 10,000 Btu or less in bedrooms and 6,000 Btu or less in Bathrooms. As always check local codes
States Prohibiting Sale/Use of Vent-Free Products

Technical Tips

Replacement Parts

Home: Contact Us